Rebar straightening machines, also known as Rebar straightening machines, the structure of the machine is to adjust the angle of the straightening die by rotating the high-speed rotor to achieve the effect of straightening. It has good modulation effect, accurate cutting, simple and easy to learn, reasonable structure, convenient and safe operation, flush cutting, small error, good performance and so on. The length of straight wire can be determined at will according to customer requirements. This machine is mostly used for chicken cage, rabbit cage, construction mesh, various welding wire, Schuler board insert wire and shaped mesh with wire cut off, applicable materials are stainless steel wire, aluminum wire, cold drawn wire, wrapped plastic skin steel wire, etc. This product is divided into three specifications as follows.
HS-Z-1 type
Volume Length, width and height 1.2 x 0.4 x 0.75 (without runway)
Weight: 95kg
Motor power: 0.75kw 1.5kw
Production power: 30m/min
Diameter of adjustable wire: 1.5mm-3.0mm
HS-Z-2 type
Volume length, width and height 1.25×0.4×0.85 (without runway)
Weight: 125kg
Motor power: 1.5kw 2.2kw
Production power: 30m/min
Diameter of adjustable wire: 3.0mm-5.0mm
HS-Z-3 type
Volume Length, width and height 1.5×0.5×1.3 (without runway)
Weight: 200kg
Motor power: 1.5kw 4.2kw
Production power: 25m/min
Diameter of adjustable wire: 5mm-8mm
HS-Z-4 type
Volume Length, width and height 1.5×0.5×1.3 (without runway)
Weight: 250kg
Motor power: 1.5kw 4.2kw
Production power: 25m/min
Diameter of the wire adjustment: 8mm-12mm
Whole machine size: volume + runway
1、The installation of the Rebar straightening machines must be smooth, and the material frame should be straight and aligned with the centre line of the guide barrel, straightening barrel and lower knife cutting hole. The motor must be equipped with reliable zero protection and leakage protection device.
2, according to the diameter of Rebar straightening machines, the choice of straightening block and speed. Straighten bars shorter than 2m or larger than 9mm in diameter at low speed.
3. Do not put in reinforcing steel before the straightening block is fixed and the guard is not covered. It is strictly forbidden to open the guard and adjust the gap during operation. It is strictly forbidden to wear thread knitting gloves for operation.
4. Before feeding the material, cut off any material that is not straight, and install a 1m long steel pipe in front of the guide barrel. When the steel bar is put through, the hand and pressure roller must be kept at a certain distance.
5、Steel is adjusted until the end, personnel must avoid, in order to prevent throwing injury.
6, steel loaded into the pressure roller, hand and roller should be kept at a certain distance; machine operation shall not adjust the roller; strictly forbidden to wear wire system gloves to operate.
7、No tools or objects are allowed to be placed on the machine to avoid vibrations falling into the body of the machine.
8, discs of steel into the circle frame should be smooth, disorderly wire or steel off the frame, must stop processing.
9, has straightened the steel bar, must be divided into small bundles according to the specifications, the number of roots, loose steel should always be cleaned up and stacked neatly.